Wall Art prints are to be printed, direct to board, on Sintra or a similar white PVC type material. The thickness should ideally be 3/16″ and should be no less than 1/8″.
Holes will need to be drilled for stand-off’s in each corner. The holes should be 1/2″ diameter and drilled approximately 1.25″ from the top/bottom and side.
The 24″ x 36″ prints require four (4) stand-offs (one in each corner) and the 40″ x 60″ prints require six (6) stand-offs. When using six, vertically center the stand-offs and have them 1.25″ in from each side.